SLSUP-100
Adapter Plates
for D-LIGHTZ and
E-LIGHTZ Mini

This adapter plate is designed to allow the following LED Downlight products to be retrofitted in place of an old style recessed luminaire:

D-LIGHTZ Tilt
D-LIGHTZ LG
E-LIGHTZ Mini
E-LIGHTZ Mini Low Power

The outside diameter of this adapter plate is either Ø130mm or Ø155mm, therefore you will be able to install any of the above products with the adapter plate into an approx. 100-140mm cutout. Simply remove the entire old light fitting and install the product complete with adapter plate. Once installed you are then able to pack insulation completely around the product.

The E-LIGHTZ Mini and D-LIGHTZ products all share the same trim profile allowing them to be used in the same lighting scheme. Three trim colours available.

Define Your Product

Select the options below to define your product
Please select one option from each line.
Options will remain to enable product selection.
All lines must be selected to show a product.

Light Level and Beam Generator

Usage instructions

Use the below graphic to assist in visualising how the selected luminaire will effect your design space

Select the options to the left to define your product
Select the room height in the text box at bottom of graphic
Move the slider on the left of the graphic to position the desired lux level height, i.e. for a desk at 700mm and a room height of 2400mm move the slider to 2400-700 = 1700mm
Select the options on the left and watch the lux levels change depending on diffuser, beam angle, CCT and driver
Try various combinations of the above to achieve the desired lux levels and beam spread
When happy with the luminaire selected, copy and paste the full product code from beneath the graphic into your specification